日本思達CEDAR數顯扭力螺絲刀

簡要描述：上海卓君電子專業代理日本思達CEDAR DID-4 數顯扭力起子數顯扭力螺絲刀，詳細： / （銷售部）高
LC液晶顯示；RS232C輸出口；扭力測試功能；數據記憶功能；操作簡單方便。

產品咨詢聯系我們

產品介紹

CEDAR DID-4扭力螺絲刀

特點:LC液晶顯示；RS232C輸出口；扭力測試功能；數據記憶功能；操作簡單方便。

規格:

Specification		DID-4
Measuring range		0.020 - 4 N-m
		0.20～40 kgf-cm
		0.20～35 lbf-in
Accuracy		± 0.5% （in case of reading 499 or less = last digit +/- 3 reading）
Display		The 4 figures digital display of LCD
The measurement direction		CW-CCW （right and left）
Measuring mode	P-P Peak	Holding Peak Load Value
	T-R Track	Showing Real time torque value （ Used for Zero-Adjustment ）
	P-D Peak down	Holding Load Value at the moment to change from upward to downword
	C Real-time output	Load torque value is outputted every about 1/ 160.
Decision function	Setting of torque value	Programmable High and Low setpoints with both audible beep and Green/Red LED indicator for uniform torque tightening or GO/NO GO testing
The Maximum, the minimum, and the average value		Displays, memory and output the data number, the maximum, the minimum, and the average value of the measured value to 30 data. It can save by a maximum of 10 channels.
Data spec.	Data transfer	ASCII format （Baud rate : 19200） When outputting data,the cable（USB miniB） is needed.
	Data memory	800 data / ten channels data
A setup of the number of counts		One to 99 count （count in a direction with a bundle）
Power supply		Ni-Cd chargeable battery 1.2V×4cells 600mAh
Auto power save		10 minutes no use, automatically switch off.
Charging time		From empty - less than 5hours
Continunous working time		12 hours
Bit /Socket part		HEX6.35
Weight		about 400g